Sunforce Triple Head Solar Light Installation Guide

this is the sunforce triple head solar motion activated light install brought to you by ultimate tech hub the sun 4 solar light has three rotating heads for maximum light coverage from multiple angles and remember if you like this video give a thumbs up and share it if you love it hit subscribe it's free the light detects motion up to 30 feet away and the detection range is up to 180 degrees it illuminates downwards horizontally and upwards let's install it i do have a spoiler alert when installing these light in the solar panel attach them both to a wooden socket do not attach to stucco the light comes with cheap wall anchors that do not hold up well in stucco i installed two of these light kits the first light installed to the stucco i soon realized it wasn't very secure so i installed the solar panel to the wooden soffit which is much better and more secure use the provided template to mark the hole locations for the light bracket you can see right here i used a level to make sure it was straight and not crooked perfect and finish drilling out the holes next insert the cheap wall anchors and tap them in with a hammer next attach the light with the provided screws but leave about an eighth of an inch so the bracket can slide into the screw heads i'll show you right here see the screw should be just far enough out so the bracket fits on tightly now take the bracket and insert it over the screw heads and push it to the right done and you can see it's not super secure it's good enough right now but it's not super secure now let's install the solar panel to the socket right above the light this panel has four holes for screws however i'm only going to use two holes and since we're installing this into the wooden socket should be plenty secure make sure the solar panel has room to move before securing it to the socket you want to be able to move up and down and sideways you can see i'm only using the top two holes since i'm screwing into the wood it's very secure and won't move even in the wind very secure not going to move now just plug in the solar panel to the light with the core provided and you're done the plug goes right here on the bottom left of the light right there okay so here's the connection to the stucco it's not super secure it will hold up but i may switch it to the soffit later so before using the solar light you should let the solar panel charge the batteries for three days make sure the power set to the opposition then after three days set it back to auto so i want to thank you for watching and if you like this video give a thumbs up and share it if you love it hit subscribe it's free thank you again for watching this is the second light kit i installed on the other side of my house i installed the light kit and the solar panel to the wooden soffit as you can see it's very secure next angle the solar panel to face the sun to get maximum exposure you